We’ve reviewed USB to SATA adapters in the past, and we stand by any of our choices. For example, suppose you just want to plug in a drive for diagnosis? Or what if you just need to attach an old drive for a few minutes to retrieve old data? In that case, a simple USB to SATA adapter might be a better choice. But for temporary use, there are better options. If you’ve got no better option, it’s a perfect solution for long-term installation. Needless to say, using a molex to SATA adapter isn’t always the best solution. Using the wrong adapter will void your hard drive’s warranty, turning even a brand-new drive into a brick. In our reviews, we’ve tried to explain what voltages and drives are best-suited for each-other. Make sure you’re using the right voltage cable for your drive, and all should be well. That said, there are some quirky adapters and quirky drives on the market. Most adapters support both of these options. Typically, most SSDs use 5.5-volt power, and most HDDs run on a 12-volt current. If you’re not paying attention to your drive’s power requirements, you can easily cause damage. However, there’s another way to damage your PC with a molex to SATA adapter. We’ve chosen well-designed molex to SATA adapters, so this shouldn’t be a problem. More likely, it will damage your hard drive, and can even cause a fire. At the very least, this will destroy your adapter. Instead, the arc will melt through the plastic insulation until it shorts out to another voltage line. However, because the current is initially diverted to the ground cable, safety shutoffs will not trigger. Normally, a short of this nature would cause your PSU’s safety features to trigger and shut off the current. In a poorly-manufactured adapter, power can arc from the 5.5-volt or 12-volt wire to the ground wire. This is essential, because poor shielding and tips are the cause of our safety concerns. Look for good shielding, and a tip that’s crimped, not molded. The first thing to do is to choose an adapter that’s properly manufactured. That’s downright terrifying! So how do you avoid it? Under the “right” circumstances, your computer can catch fire. And we don’t just mean that you can lose your hard drive. An improperly-manufactured molex to SATA adapter can pose a serious safety risk. There’s a saying in the IT world: “Molex to SATA, lose all your data.” Now, this is a bit of an exaggeration, but there’s some truth to it. We’ve picked three of the industry’s leaders, and taken an in-depth look to see how they perform. Today, we’ll be looking at the best molex to SATA adapters that money can buy. It’s a 1TB drive that installs quickly and painlessly. If you’re interested in going this route, check out our review of the Kingston KC2000. On the other hand, it also ties up one of your PCI Express slot, limiting your options for future upgrades. Some newer SSDs plug directly into your PCI Express slot, eliminating the need for a SATA cable altogether. Then plug your hard drive into the other end, and you’re good to go.Īs SSD drives have gotten smaller and smaller, you actually have a third option. Instead, all you need to do is plug the adapter into your PSU. By going this route, you won’t need to worry about swapping out your power supply. Replacing a power supply is equivalent to major surgery.Īnother option is to use a molex to SATA adapter cable. Adding a hard drive is a relatively painless, plug-and-play operation. This is especially true if you’re adding a drive to an existing build. But upgrading your PSU isn’t always a convenient option. This way, you can get the SATA connections you need. One option is to simply purchase a newer PSU.
0 Comments
Leave a Reply. |